FULL APPLICATION
CORRECT AMOUNT OF BOND
CORRECT POSITIONING
HOW TO OVERLAP
HOW TO REMOVE LASHES
HOW TO CLEAN LASHES
HOW TO LASH DUPE
-
- Apply a small amount of remover onto your lash extensions. Gently massage the remover into the lashes.
- Allow the remover to sit for one minute.
- Utilize a Spoolie to carefully slide the lashes off.
- Use our Lash Dupe microfiber cloth to eliminate any remaining excess remover oil.
-
- Dispense a pump of foam cleanser onto a microfiber pad and use it to clear the area around the eye, ensuring thorough makeup removal.
- For cleansing along the lash line, take a small pump of foam cleanser and use a clean makeup brush, such as an eyeshadow brush, to gently cleanse along the top of the lashes and remove any dirt. Remove any excess cleanser using the same small makeup brush, cleaned in cold water. Finally, fluff up the lashes again using a spoolie.
-
The correct position for the lashes is 1-2mm away from the waterline.
Β Be sure to avoid attaching your Lash Dupes to your skin, and only to your natural lashes.Β
-
- Gather all necessary tools for the lash application.
- Begin by thoroughly removing all eye makeup, and then cleanse your lashes to remove any dirt and oil. We recommend using our Foam Cleanser for this purpose.
- If you have straight lashes, consider curling them to facilitate easier application.
- Carefully remove the lashes from the book and trim any excess band on the outer pieces using lash scissors.
- Lay the lash segments out on the gel lash pad to prevent them from moving around, ensuring to maintain the correct lash sequence.
- Apply a thick, even band of glue and allow it to dry for 3-4 minutes, using the pink timer provided for timing.
- Begin applying the lashes underneath as usual, starting from the outer corner. To facilitate easier application, consider using your spare hand to gently pull your eyelid upwards, ensuring a 1-2mm gap between your lashes and the waterline.
- If necessary, trim the inner piece to fit the size of your eye.
- Once all lashes are applied, gently go along the lash line, pushing upwards into the lashes with the flat side of the tweezers or sanitized fingers.
- Allow the lashes to dry for 15 minutes.
- Finally, press the lashes with the new gold tweezers for a secure hold.